re:3D Gigabot, Installation Manual

Page: 107 / 115

n43
n44
n45
The Y cable carriers should
be able to connect to the
links on the machined
corner plate. The corner
plate links are flipped
around so as to rotate the
opposite direction.
If these do not connect, you
may need to remove the
tabs on the connecting link
as shown. Carefully scrap
this away with a sharp utility
knife or x-acto knife. You can
also use a rotary tool such
as a Dremel or a drill press
to grind this away. After
removing the tabs, connect
the links.
Check your work all the
way down the Y axis and
ensure that the wires
remain parallel with no
overlaps or tangles.
Use a small screwdriver
to reposition them as
needed, or open the cable
carrier doors for better
access.
gigabot
®
: unassembled
247