Raymarine E70085 Dragonfly, Operation Manual

Page: 21 / 96

4.2 Mounting the transducer
The transducer must be mounted on the transom using the
mounting bracket provided. The steps below describe the
initial mounting steps required in order to test your transducers
performance. After testing the transducer you must finish
the mounting following the instructions in the
Finishing the
transducer mounting section.
1. Fix the transducer mounting template to the selected location,
using masking or self-adhesive tape.
1
2
3
D12632-1
1 Transducer mounting template
2 Waterline
3 Mounting away from propeller
2. Ensure the template is parallel to the waterline.
3. Drill 2 x holes for the adjustment slot screws as indicated
on the template.
Note: Do NOT drill the third mounting hole at this stage.
4. Fill the 2 holes with marine grade sealant.
5. The kick-up adjustment screw may need to be loosened to
gain access to the mounting holes.
00
1
D12653-1
1 Kick-up adjustment screw
6. Ensure the transducer and bracket pivot arm are hooked
over the mounting bracket back plate as shown below.
00
00
00
0
0
D12651-1
7. Lift up the transducer and pivot arm to access the mounting
holes.
00
00
00
00
00
D12652-1
8. Using the screws provided, temporarily secure the mounting
bracket using the adjustment slots on the back plate.
1
2
D12633-1
1 Locking hole
2 Adjustment slots
9. Push the transducer and pivot arm down until the bracket
clicks into place.
10. Loosen the transducer pivot bolt approximately 3 turns to
enable adjustment.
1
D12643-1
1 Pivot bolt location
11. Adjust the angle of the transducer using the ratchet
mechanism, one click at a time until the transducer face is
parallel with the waterline.
Location and mounting
21