Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 37 / 82

4
P/N 016-0171-509 Rev. E 33
CALIBRATION
The following settings must be calibrated or programmed to ensure proper control and operation of each
injection pump:
NOTE: These settings must be programmed for each injection product or pump which will be used to
control product during an application. Refer to the specific control console manual for instructions on
programming these settings or other calibration information on the console.
To access the Raven Product Control screen and begin calibrating the Sidekick Pro™ ISO injection pump:
1. Select the UT display menu.
2. Locate the ISO injection pump icon in the UT menu similar to the following.
NOTE: The UT menu will display a pump icon for each pump detected on the ISOBUS system.
3. Select the desired pump number to calibrate and proceed to the following sections to set up the Sidekick Pro™
ISO direct injection pump for the first time:
Raven ISOBUS Interface Screen Required Settings
Product Information
Pump Number (see the Detecting and
Addressing the Motor Control Node section
on page 31)
Product Home Screen
Pump Mode section on page 34
Target Rate section on page 34
Tank Volume section on page 35
Product Setup Screen
Pump Size section on page 36
Meter Cal section on page 36
Valve Cal section on page 36
Valve Cal 2 section on page 37
Direct Injection (DI) Tank Capacity section on
page 37
Pressure Cal section on page 37
Rate Bump (±) section on page 38
Display Smoothing section on page 39
Zero Speed Shutoff section on page 39
Agitator Enable section on page 39
Ratio Rate Enable section on page 39
Alarm Setup Screen
Low Tank section on page 40
Off Rate section on page 40
FER Cal section on page 40
Low Limit section on page 41