Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 34 / 82

C
HAPTER
3
30 Sidekick Pro™ ISO Installation & Operation Manual
VERIFY INSTALLATION OF THE SIDEKICK PRO™ ISO
NOTE: If more than one injection pump is installed on an ISOBUS system, it may be necessary to readdress
the motor control nodes on each pump. Refer to Detecting and Addressing the Motor Control Node
section on page 31 for assistance with readdressing the ISOBUS motor control nodes.
Perform the following procedure to verify that the system is installed properly:
1. Fill the chemical supply tank with clean water.
NOTE: Before filling the tank with chemical for the first time, thoroughly vacuum the chemical supply tank
and clean any plastic or metal particles that may be left from the manufacturing or installation
process. If these particles get stuck within the injection pump, they may cause a significant reduction
in pump accuracy.
Turn the hand valve(s) to allow the tank to drain without running through the pump or injection
plumbing and thoroughly rinse tank prior to testing or running the injection system for the first time.
2. Verify all calibration settings for each injection node on the ISOBUS system are set. Refer to Chapter 4,
Calibration.
3. Prime and calibrate the pump as described in Prime the Injection Pump section on page 43.
4. Set a target rate for the chemical injection and run the pump in Auto application mode as described in Product
Home Screen Calibration Settings section on page 34.
5. Check for any leaks on all plumbing connections before applying chemicals with the injection system. It is also
recommended to check the system periodically and replace worn or damaged connections, valves or hoses.