Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 74 / 82

C
HAPTER
8
70 Sidekick Pro™ ISO Installation & Operation Manual
1. Disable and shutdown any automatic product control features of the Sidekick Pro ISO injection system and turn
off the vehicle when replacing the vacuum switch assembly.
2. Disconnect the vacuum switch connector from the motor control cabling. Be careful to keep dust, debris, or
liquid chemicals which may seep from the injection pump head from contaminating the cable connections.
3. Loosen the vacuum switch while securing the connected fitting to prevent damage to the pump head.
4. Apply RectorSeal
®
or equivalent thread sealant to the new vacuum switch and thread into the pump head.
5. If necessary, slide the protective covering on the vacuum switch back slightly to expose the hex surface for
tightening the vacuum switch body.
6. Tighten the vacuum switch body two or three quarter turns to secure the vacuum switch.
NOTE: Do not over tighten the pressure transducer. Overtightening the pressure transducer may damage
the pump head.
7. Be sure to replace the protective cover over the flow switch before operating the pump.
INJECTION PUMP FLOW MONITOR SENSOR
Perform the following procedure to replace the flow monitor sensor (P/N 063-0173-492).
FIGURE 3. Pump Head and Flow Monitor Sensor
1. Disconnect the sensor cable from the motor control cabling.
2. Loosen the locking nut on the sensor assembly and remove the old sensor assembly from the pump head.
3. Loosen the sensor bracket mounting screws enough to allow the bracket to slide freely on the pump head.
WARNING
Hazardous chemicals may be under pressure
even if the pump has not been in service recently.
Before replacing any components on the
injection pump, thoroughly rinse the injection
pump with clean water to remove excess
chemical residue.
Pump Inlet
Port
Sensor
Bracket and
Screws