Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 38 / 82

C
HAPTER
4
34 Sidekick Pro™ ISO Installation & Operation Manual
•
Product Home Screen Calibration Settings section on page 34.
•
Product Setup Screen Calibration Settings section on page 35.
•
Alarms Setup Screen Calibration Settings section on page 39.
Once the calibration settings or values on these screens are configured or set, the Sidekick Pro ISO pump may
be controlled with the UT display.
PRODUCT HOME SCREEN CALIBRATION SETTINGS
The Product Control Home screen display provides access to the following calibration settings for the Raven
Sidekick Pro™ ISO direct injection pump:
PUMP MODE
The current pump mode is displayed at the top of the Product Control Home screen. Select the pump mode to
change the operation mode of the injection pump between CAL/PRI/RNS, Manual, Auto and Rx.
NOTE: The CAL/PRI/RNS mode will be used during the pump calibration, prime, or rinse process. Refer to
Chapter 5, Operation, for information on the manual, automatic and Rx pump modes.
TARGET RATE
The programmed target rate for operations is displayed in the Rates area to the right side of the Product Control
home screen. Enter the desired rate of injected chemical in ounces per acre [deciliters/hectare].
Verifying Flow Rate Limits. Before starting actual field operations, use the following formula to verify that
Sidekick Pro™ ISO is capable of applying at the target application rate and speeds:
Be sure that the calculated volume per minute is within operating tolerance of the injection pump installed on the
implement.
FOR EXAMPLE:
Flow Output Range
P/N 063-0173-402
5-200 oz./min.
[1.5-59 dl/min.]
P/N 063-0173-403
1-40 oz./min.
[0.3-11.8 dl/min.]
Tank
Volume
Pump Mode Target Rate
Volume Minute
⁄
Rate Speed
×
Width
×
5940 60 000
, [ ]
-----------------------------------------------------------
=