Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 39 / 82

4
P/N 016-0171-509 Rev. E 35
CALIBRATION
When using U.S. units, given a target rate of 75 oz./acre, a target application speed of 11.0 MPH, and a boom
width of 85 ft. (1020 in.):
Thus, the desired rate of 75 oz./acre is within the capacity of the 5 - 200 oz./min. pump, but will not be
acceptable for the 1 - 40 oz./min. pump.
When using Metric units, given a target rate of 50 dl/ha, a target application speed of 17.0 km/h, and a boom
width of 25 m (2500 cm):
Thus, the desired rate of 50 dl/ha is within the capacity of the 1.5 - 59 dl/min. pump, but will not be acceptable
for the 0.3 - 11.8 dl/min. pump.
TANK VOLUME
Select the tank volume indicator during field operations to enter the volume of product used to fill the tank. This
volume is used to calculate the volume remaining in the tank and for the low tank alarm if enabled.
It is only necessary to enter a non-zero value during the initial pump calibration and while verifying the pump
installation. Review the Verify Installation of the Sidekick Pro™ ISO section on page 30 for the proper procedure for
checking the pump installation.
NOTE: Refer to Chapter 5, Operation, for more information entering tank product volumes and operating
the Sidekick Pro™ ISO during field operations.
PRODUCT SETUP SCREEN CALIBRATION SETTINGS
1. Select the Tools icon from the soft keys area on the right side of the Product Control Home screen.
Volume Minute
⁄
75 11.0
×
1020
×
5940
-----------------------------------------
141.67
oz min
⁄
= =
Volume Minute
⁄
50 17.0
×
2500
×
60000
-----------------------------------------
35.42
dl min
⁄
= =