Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 40 / 82

C
HAPTER
4
36 Sidekick Pro™ ISO Installation & Operation Manual
2. Touch the Product Setup icon along the top of the UT display.
3. Refer to the following sections for information on the displayed settings and options. Once all settings have
been programmed for the selected pump, proceed to the Sidekick Pro™ ISO Priming and Calibration section
on page 43 to test operation of the pump.
PUMP SIZE
Select the size of the injection pump at the selected address. Select the 5-200 oz./min. [1.5-59 dl/min.] for the high
volume pump or 1-40 oz./min. [0.3-11.8 dl/min.] for the low volume pump.
METER CAL
The meter cal value for the Sidekick Pro™ ISO injection pump may be found on the label located on the pump
motor. Enter this value as the initial meter cal in the control console.
NOTE: The meter cal may be adjusted to refine calibration of the chemical injection pump. Refer to the
Calibrate the Injection Pump section on page 44 to check or refine the meter cal.
FIGURE 1. Sidekick Pro™ ISO Pump Motor Label with Meter Cal
VALVE CAL
The valve cal is used to modify the control response of the injection pump and adjust how the pump controls the
injected product. The default valve cal value for any injection pump is 123.