Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 41 / 82

4
P/N 016-0171-509 Rev. E 37
CALIBRATION
Each digit in the calibration number corresponds to a specific function of the valve. The following functions apply
to the digits in the valve calibration number:
NOTE: The initial valve cal may be adjusted to refine Sidekick Pro ISO system response for various
application needs.
Valve Speed Digit. This value controls the response time of the control valve motor. If the valve speed setting is
too fast, the valve will over correct and the system may start to oscillate. When operating a Sidekick Pro ISO
injection pump, this value has a range from 0 to 9, with 0 being slow and 9 being fast.
Brake Point Digit. The break point digit sets the percent away from the target rate at which the control valve
starts to turn at a slower rate so that it does not overshoot the target rate. The values range from 0 to 9, where 0 is
a 5% rate, 1 is a 10% rate and 9 is a 90% rate.
Dead Band Digit. The dead band digit is the allowable difference between the target rate and the actual
application rate. The values range from 1 to 9, where 1 equals 1% difference and 9 equals 9% of the difference.
VALVE CAL 2
The valve cal 2 value is not editable by the vehicle operator. A customer service key is required to modify this
value. The default value for a high volume pump is ‘5054’ and for a low volume pump is ‘5055.’
DIRECT INJECTION (DI) TANK CAPACITY
Enter the capacity of the direct injection chemical supply tank in gallons.
PRESSURE CAL
Before operating the Sidekick Pro ISO system, calibrate the pressure transducers which monitor both the injected
chemical and carrier product pressures.
Pressure of the injected product is monitored by a pressure transducer connected to the Sidekick Pro ISO pump.
Pressure of the carrier product is monitored by an optional boom or carrier product line pressure transducer.
Valve Speed Digit
Break Point Digit
Dead Band Digit