![background image](http://html.mh-extra.com/html/raven/omnirow/omnirow_installation-manual_788985024.webp)
Chapter 3
20
White MultiRow OmniRow™ Installation Manual
Install the OmniRow Valve Pressure and
Tank Hoses
FIGURE 21.
OmniRow Valve Pressure and Tank Hoses Installed
Refer to the supplied machine-specific hydraulic installation sheet included with the OmniRow installation kit to
install the OmniRow hydraulic valve pressure and tank hoses.
Important:
Pay close attention to the hydraulic hose part numbers on the diagram and the locations in
which each must be installed.
Note:
Install the supplied 90° elbow fittings (P/N 333-0012-108) on the OmniRow hydraulic valve as
needed when installing the hydraulic hoses.
FIGURE 22.
Hoses Clamped
Note:
Use the provided hose clamps (P/N 434-2000-001) to secure the installed hydraulic lines to each
end of the machine’s draw bar as illustrated in the figure above.
1.
Install the supplied hydraulic hose labeled P on the fitting installed in Port P of the OmniRow valve.
2.
Install the supplied hydraulic hose labeled T on the fitting installed in Port T of the OmniRow valve.