3
Manual No. 016-3001-012
13
Hydraulic System Installation
7.
Insert the supplied cotter pin (P/N 312-0000-395) in the hex coupler to secure the installed shafts.
8.
Secure any wires within close proximity of the installed hydraulic motor to prevent interference with the
operation of the row unit.
Note:
Do not secure the wires between the motor and the row unit mounting bracket, as this makes it
difficult to access the wires if maintenance is required.
9.
Verify the motor, shaft, and bearings are aligned.
10.
Tighten the nuts to secure the installed motor and mounting bracket to the row unit.
11.
Repeat the steps above to install hydraulic motors on the remaining left mounting planter row units.
Right Mounting
1.
Replace the existing sprocket/bearing bracket hardware with two 3/8”-16 x 1-1/2” bolts (P/N 311-0054-107).
FIGURE 13.
Mounting Bracket Installed
2.
Loosely secure the motor mounting bracket to the right side of the row unit using two 3/8” zinc flanged lock
nuts (P/N 312-1001-164).
P/N 107-0172-010