![background image](http://html.mh-extra.com/html/raven/omnirow/omnirow_installation-manual_788985022.webp)
Chapter 3
18
White MultiRow OmniRow™ Installation Manual
Important:
Pay close attention to the hydraulic hose part numbers on the diagram and the locations in which each
must be installed. Install all pressure hoses before installing tank hoses.
Note:
As illustrated in the installation sheet, there are tee fittings installed to connect the pressure and
tank hoses to the open center pressure-reducing valve. Additional 45° and 90° elbow fittings are
also supplied to assist in routing the hydraulic hoses around obstacles. Install these additional
fittings as needed.
Some of the supplied hoses contain both straight and 90° ends. When installing the hoses, the 90°
ends of the hoses should be installed on the ends of the fittings that point up. The straight ends of
the hoses are installed on the 90° elbow fittings installed on the end row units. Refer to Figure 19
on page 18.
FIGURE 19.
Hose Installation Illustration
Middle Row Unit Assembly
End Row Unit Assembly
Install 90° hose ends on
the fittings pointing up
Install straight hose
ends on the fittings on
90° elbow fittings
90° hose ends
installed
Straight hose ends
installed on 90°
elbow fitting