3
Manual No. 016-3001-012
15
Hydraulic System Installation
FIGURE 15.
Mounted Pressure Gauge Test Kit
1.
Install the tee fitting and gauge coupler between the PWM valve and the OmniRow hydraulic motor.
2.
Disconnect the hydraulic hoses in the mounting location.
3.
Install the pressure gauge test kit fittings in the appropriate location in the hydraulic system.
Install the OmniRow Hydraulic Valve
Note:
Refer to the machine-specific installation guide to determine the appropriate mounting location for
the OmniRow hydraulic valve. Additional hardware and mounting plate modification may be
required.
Install the Fittings on the Valve
Before mounting the OmniRow hydraulic valve on the machine, install the proper fittings in the valve. This
prepares the valve for installation and simplifies the hose connection process later in the procedure. Refer to
the following table to install the fittings in the appropriate ports of the OmniRow valve.
P/N 333-0012-311
P/N 333-0012-307
P/N 417-0001-029
P/N 333-0012-309
P/N 333-0012-045
P/N 333-0012-043
P/N 333-0012-086