![Raven OMNiDRIVE Installation And Operation Manual Download Page 82](http://html.mh-extra.com/html/raven/omnidrive/omnidrive_installation-and-operation-manual_788984082.webp)
Chapter 2
CAUTION
Secure or lower the steering column to prevent the steering
wheel from falling unexpectedly.
2. Using a socket, remove the bolt upon which the brake pedals pivot.
Note:
There are two washers installed on this bolt from the factory. One washer is
installed between the pedals and one washer is installed between the left pedal and
the steering column. When reassembling the brake pedals and brake stop weldment
bracket, these washers must be replaced in the same locations.
3. Grasp the brake pedal above the brake rod and e-clip and pull straight up to remove
the OEM brake rods from the cab floor.
4. Remove E-Clips and pins which hold the brake rods to the pedal assemblies to release
the OEM brake rods.
82
Summary of Contents for OMNiDRIVE
