![background image](http://html1.mh-extra.com/html/raleigh/ebike/ebike_user-manual_3522681162.webp)
V User Manual Impulse Pedelec
13
4.2 Charging operation
Before charging the battery, read the information on the
charger carefully.
›
1. Take the charger and docking station provided
out of its packaging and plug the mains plug into a
socket (230 V, please observe type plate on the
charger).
Type plates on charger and docking station
To charge the battery safely, the charger must be
placed on a suitable surface resting on its four
feet with the LED facing upwards. This is the only
way to ensure that the hot air around the battery
warmed during the charging operation can dissi-
pate via the surrounding ventilation slots.
›
2. Connect the charger to the docking station. The
LED in the docking station now lights up briefly in
red and then permanently in green.
›
3. Put the battery in the holder of the docking
station. The battery and charger are connected. The
LED in the charger lights up in green.
Battery in the docking station
›
4. The charging operation starts. The LED in the
charger now lights up green. The battery LEDs light
up one by one to indicate the progress of the charg-
ing operation. The battery is charged in five stages.
When charging of one stage is in progress, the cor-
responding LED flashes. If this stage has been fully
charged, the LED will light up permanently. Now
the next LED will begin to flash.
After all five LEDs have gone out, the battery is
fully charged.
›
5. If the LED of the charger flashes red permanent-
ly, a charging fault has developed.
Take the battery out of the charger, then put it back
in. The charger tests the battery and performs
readjustments, if required. If the LED on the charger
still flashes, take the charger and battery to your
specialist dealer. He will test the devices and
replace them, if required.
›
6. To save power, pull the charger plug out of the
socket once the charging operation is complete.
4.3 Fitting the battery
›
1. Insert the battery into the battery holder of the
Pedelec from the left by tilting it outwards at
roughly 45°.
Reinstalling the battery
›
2. Make sure in doing so that the lateral guides at
the bottom of the battery are also inserted into the
guides in the holder.
›
3. Tilt the battery towards the bike until it
engages in the locking mechanism. If the key is
still in the lock, turn it clockwise then pull it out to
lock the battery in place.
›
4. Make sure the battery is firmly in place.
Summary of Contents for ebike
