Raleigh Audio Premium Extreme RAKK dac, Assembly Manual

Page: 24 / 65

Panel Assembly
Bottom Panel Assembly
Steps preceded by a “note” ( ♪ ) deal with components which must be oriented properly.
TIP – To ease the alignment of the mounting holes with standoffs, slightly loosen the standoffs
from the board, install the screws through the bottom panel into the standoffs and then re-tighten
the standoffs.
————————————————————————————
♪
Mount the power transformer
1. Mount the LL1683 transformer in its location using the four 4mm metric screws. Orient the
transformer such that the high-voltage (shorter) pins are towards the front of the panel. The
front of the panel has the lip.
•
Dress each of the grey twisted pairs that will be attached to the Regulator Modules
toward the edge of the panel.
•
Dress the grey twisted pair that will power the filaments toward the center of the panel.
•
Dress the red/red/black twisted trio toward the center of the panel.
————————————————————————————
23