Pre
wire
the
12V
Power
Supply
(for
the
Active
Output)
————————————————————————————
12.
Install a 10K resistor in location R4.
————————————————————————————
13.
Prepare an 11” #22 red/black twisted pair.
•
Connect the red wire to the DC Output “+” pad.
•
Connect the black wire to the DC Output “-” pad.
————————————————————————————
14.
Prepare a 9” long #20 green wire and connect it to the DC Output “+” pad.
————————————————————————————
15.
Prepare a 13” #22 white/violet twisted pair.
•
Connect the white wire to the LED “C” pad.
•
Connect the violet wire to the LED “A” pad.
————————————————————————————
16.
Prepare a 6” #20 white/black twisted pair.
•
Connect the twisted pair to the inner-most “AC Input” pads.
————————————————————————————
17.
Fabricate a T-shaped AC power cable as follows:
•
Cut a #20 black wire, 7½ inches long. Do not strip the ends.
•
Cut a #20 black wire, 23 inches long. Do not strip the ends.
•
Cut a #20 white wire, 24½ inches long. Do not strip the ends.
•
Align the white wire with the longer black wire and twist them together for about 18”.
•
Align the other black wire with the other end of the white wire and twist them together
for 4½”.
•
Go back to the first pair (that you twisted to 18”) and continue the twist until you get to
the junction of the second pair.
•
Now twist the two black wires together until you get to the end. Don’t worry if the two
black wires are different length – you will trim them later.
————————————————————————————
12
Summary of Contents for Premium Extreme RAKK dac
