Rain Master RME HAWK, User Manual

Page: 41 / 72

REVIEWING PROGRAMS AND TOTALIZER
A unique feature of the HAWK controller is its REVIEW feature. At the push of a key, all
program information will be displayed. Successive pushes of the REVIEW key cause the
information to advance. Another way of reviewing information is to press and hold the Review
key. As the key is held the information will automatically advance at a readable rate. Removing
your finger causes the scrolling information to stop. Pressing QUIT at any time will return
the controller to the Automatic Mode.
The information for the programs will start with information for the program selected (via
the PROGRAM function key) and continue until Program 4. For instance if Program 1 is
the selected program then information in Program 1 will be displayed first, followed by Program
2,3 and 4 and if Program 3 is the selected program then information in Program 3 will be
displayed first, followed by Program 4.
The information presented is as follows:
1. If the flow feature was enabled (via SETUP), and Program 1 was the last selected
program, then TOTAL…GALLONS… will be displayed
Note: When using the REVIEW function, the total gallons screen records and updates
measured gallons every 10 seconds. It can be used to check for unscheduled flow.
2. If the Rain Sensor has been Enabled via Setup for this program then:
SNSR-WET or SNSR-DRY will be displayed.
3. Start Times 1, 2, 3, 4 and 5 (displayed as Start Times).
4. Water Days (displayed as W DAY)
5. Skip Days (displayed as SD) and the number of days left until the next watering
(displayed as LFT)
6. Percentage (displayed as PT)
7. Stations and their runtimes (displayed as STATIONS). If the program is a cycle and
soak program (as selected via Setup), the maximum watering time and soak time will
also be displayed for each station.
Note: The runtime shown for each station is the programmed length and will not be
changed by the value you may have set for the percentage adjust function.
8. The total watering time for the program (displayed with H [hours] and M [minutes]). This
is the actual watering time and takes into account all factors including the percentage
adjust, any delay between stations (set via Setup) and any adjustments needed because
the program is a Cycle and Soak program. The displayed value is rounded up; for instance
a total time of 2 hours, 12 minutes and 14 seconds will be 2 hours and 13 minutes.
39