Rain Master RME HAWK, User Manual

Page: 36 / 72

STATIONS (for a Cycle and Soak program)
This is used to select the stations and set the runtime, the maximum watering time and
the soak time for each station. After entering the desired station number, the runtime is
entered followed by the maximum watering time, and finally the soak time. Percentage
is briefly shown at the beginning to remind you of its setting. The percentage only applies
to the runtime and not to the maximum watering time or soak time. Selected stations are
shown at the top of the display. The program number is shown in the display as a
convenience.
Note: If a pump is assigned to any program (via Setup) then station 1 cannot be selected
as it is reserved for the pump.
EXAMPLE: You wish to set Station 1 for a runtime of 1 hr and 5 minutes, a maximum
time of 35 minutes and a soak time of 45 minutes and station 6 for a runtime of 2 hrs, a
maximum time of 1 hr and a soak time of 20 minutes. (You must have previously set, via
Setup, the program for which you are entering information, to a cycle and soak program.)
Press:
(controller will momentarily display “RUN TIME”)
(controller will momentarily display “MAX TIME”)
(controller will momentarily display “SOAK TIME”)
(controller will momentarily display “RUN TIME”)
(controller will momentarily display “MAX TIME”)
(controller will momentarily display “SOAK TIME”)
Press:
The controller goes back to Automatic Mode
Note: If the same station appears in multiple cycle and soak programs, only one value for
the maximum time is allowed across programs. The same holds true for soak times.
34
STATIONS
SUN
1
ENTER
SUN
1 0
THU
5
ENTER
TUE
3
THU
5
ENTER
WED
4
THU
5
ENTER
FRI
6
ENTER
MON
2 0 0
ENTER
SUN
1 0
ENTER
0
MON
2 0
ENTER
QUIT