Rain Master RME HAWK, User Manual

Page: 6 / 72

4
USER PROGRAMMABLE FEATURES (SETUP)
The following features can be easily selected or reconfigured by a single push of a button
(SETUP key)
• Programmable Master Valve allows you to program a Master Valve to go on
by program.
• Programmable type of Master Valve allows you to select either a Normally
Closed Master Valve or a Normally Open Master Valve.
• Programmable Pump allows you to program a Pump (independent of the
Master Valve) to go on by program.
• Programmable stacking or no stacking of programs allows you to have programs
run one after the other (Stack Mode) or at the same time (No Stack Mode).
• Programmable timer delay between stations allows you to program a time
delay from 0 to 255 seconds (4 minutes 15 seconds) to allow slow-closing
valves to completely shut off.
• Programmable security code allows you to enter a 1 - 4 digit number as a
security code which will prevent entry by unauthorized personnel.
• Programmable sensor allows you to have a sensor device enabled or disabled
for each program.
• Programmable alarm allows you to either enable or disable an audible alarm
in the event of a flow limit violation or a field wire fault detection.
• Programmable cycle and soak allows you to select each program to be either
a cycle and soak program or not.
• Programmable flow allows you to enable or disable the flow sensor features.
• Programmable pipe size allows you to select the pipe size for the flow sensor.
• Programmable main line flow limit allows you to set an upper flow limit from
1 to 999 GPM. This limit defines the maximum allowable controller flow
for scheduled irrigation.