Rain Master RME HAWK, User Manual

Page: 37 / 72

To clear a station and its runtime, such as Station 7,
Press:
Press:
The controller goes back to the Automatic Mode.
To review selected Stations information
Press: (An LED light will light up for every
station that has a valid runtime).
Press:
The controller goes back to the Automatic Mode.
To review the runtime, maximum time and soak time of a station such as Station 6,
Press: (the runtime is displayed)
Press: to leave the runtime as is and continue reviewing
Press: to leave the maximum time as is and continue reviewing
Press: to leave the soak time as is and continue reviewing
Press:
The controller goes back to the Automatic Mode
QUICK STATIONS (for a cycle and soak program)
This is used to rapidly program a block of stations which all have the same runtime,
maximum watering time and soak time. First the lowest station number is entered and
then the highest and then the runtime and then the maximum watering time and then
the soak time. Percentage is briefly shown at the beginning to remind you of its setting.
The percentage only applies to the runtime and not to the maximum watering time or
soak time. Selected stations are shown at the top of the display. The program number is
shown in the display as a convenience.
Note: If a pump is assigned to any program (via Setup) then Station 1 cannot be selected
as part of the block of stations as it is reserved for the pump.
STATIONS
SAT
7
CLEAR
QUIT
STATIONS
QUIT
STATIONS
FRI
6
ENTER
ENTER
ENTER
ENTER
QUIT
35