©
Copyright Qvis
Ⓡ
All software and documentation rights reserved.
56
Figure 39
Set network failure alarm parameters here: detection on/off, linkage alarm,
alarm output duration, sending e-mails when the alarm has been triggered,
linkage snapping/recording, etc.
[Enable]:
Enable or disable network failure alarm
detection.
[Linkage Alarm output]:
Supports I/O output, snapshot, and record.
[IO output]:
Enable or disable linkage alarm output
[Alarm output]:
Set the duration of the linkage alarm output
after being triggered (in seconds), the range
of the duration is 0~86400s. 0 means that
there is no limit for alarm output.
[Type]:
Two options available; either NO (Normally
Open) or NC (Normally Closed).
[Snapshot]:
When alarm is triggered snapshot pictures
can be sent via E-mail and save to a mailbox
or to an FTP server uploading. For snapping
parameters, if the number of pictures
snapped at one time is set as 10, and the
snapping interval is 1 second, that means
when there is an alarm, 10 pictures will be
snapped and the interval between each
picture is 1 second.
[Record]:
When alarm is triggered, the record files
can be saved to a specified FTP.
