Quidway WB2011, User Manual

Page: 21 / 157

System Defaults
1-7
1
• Scans all available channels and selects the best channel and data rate based on
the signal-to-noise ratio
• Manageable through an easy-to-use web-browser interface, command line (via
Telnet), or SNMP network management tools
System Defaults
The following table lists some of the wireless bridge’s basic system defaults. To
reset the bridge defaults, use the CLI command “reset configuration” from the Exec
level prompt.
Feature Parameter Default
Identification System Name Outdoor Bridge
Administration User Name admin
Password null
General HTTP Server Enabled
HTTP Server Port 80
TCP/IP IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Primary DNS IP 0.0.0.0
Secondary DNS IP 0.0.0.0
VLANs Status DIsbaled
Native VLAN ID 1
Filter Control Ethernet Type Disabled
SNMP Status Enabled
Location null
Contact Contact
Community (Read Only) public
Community
(Read/Write)
private
Traps Enabled
Trap Destination IP Address null
Trap Destination Community
Name
public