Quidway WB2011, User Manual

Page: 117 / 157

Bridge Commands
6-37
6
bridge stp-port path-cost
Use this command to configure the spanning tree path cost for the specified port.
Use the
no form to restore the default for the specified port.
Syntax
bridge stp-port path-cost < port > cost
no bridge stp-port path-cost < port >
• port - Specifies the port number on the wireless bridge. (Range: 0, Ethernet
interface; 1-16 wireless interface)
• cost - The path cost for the port. (Range: 1-65535)
Default Setting
• Ethernet interface – 19
• Wireless interface – 40
Command Mode
Global Configuration
Command Usage
• This command is used by the Spanning Tree Protocol to determine the best
path between devices. Therefore, lower values should be assigned to ports
attached to faster media, and higher values assigned to ports with slower
media.
• Path cost takes precedence over port priority.
Example
bridge stp-port priority
Use this command to configure the priority for the specified port. Use the no form to
restore the default for the specified port.
Syntax
bridge stp-port priority < port > priority
no bridge stp-port priority < port >
• port - Specifies the port number on the wireless bridge. (Range: 0, Ethernet
interface; 1-16 wireless interface)
• priority - The priority for a port. (Range: 1-255)
Default Setting
128
Command Mode
Global Configuration
Outdoor Bridge(config)#bridge stp-port path-cost 1 50
Outdoor Bridge(config)#