Troubleshooting
4-4
Rev. Date: 01/07
400-294-002
General Operation
, continued
PROBLEM SOLUTION
The machine does not
tightly fit against the sides
of the lane.
The guide rollers are set at the factory to fit wood lanes and
QubicaAMF synthetic lanes. Depending on your lanes, the
guide rollers may need to more tightly hug the sides of the
lane. To tighten the fit against the lanes, complete the steps
below FOR ALL SIX GUIDE ROLLERS to add a spacer in
the guide roller assembly. Spacers are provided in the
yellow envelope shipped with your machine.
1. With the machine in the
storage
position, remove the
Phillips screw on each end of the guide roller shaft to
release the guide roller assembly. Refer to drawing
294-115-032 (located in the Parts section).
The guide roller assembly configuration is: a spacer, a
spring, and a guide roller.
2. Insert a spacer next to the other spacer.
3. Reassemble the guide roller assembly and secure it in
place with the two Phillips screws.
The machine turns on but
doesn’t do anything when
the Start button is pressed
(first or second time).
This occurs when the EMERGENCY STOP button has been
used to turn off the power to the operations. To reset the
machine, press the toggle switch to the OFF position, wait
10 to 15 seconds, then press the toggle switch to the ON
position.
If this does not correct the problem, check the fuses. Refer
to the Maintenance section for instructions about how to
access the fuses.
Summary of Contents for Express 294-115-200
