Maintenance
400-294-002
Rev. Date: 01/07
3-23
4.
Pull the buffer brush towards the left to release its right side from the machine.
5.
Pull the entire buffer brush out from the machine.
6.
Lightly oil the spring-loaded end of the right side of the new buffer brush. Use the
same 80- to 90- weight gear oil you use to lubricate the chains.
7.
Insert the right end of the buffer brush into the sprocket on the right side of the
opening.
8.
Grasp the left end of the buffer brush and push it gently towards the right while
positioning it into its sprocket on the left side.
9.
Release the left side of the buffer brush into its sprocket.
3.4.5 Replacing The Waste Tank Seal
The waste tank seal should be smooth and flat. A waste tank seal that is wrinkled, warped,
buckled, or has started to pull away from the vacuum motor, can’t provide the seal needed
to create the vacuum to remove the cleaning residue from the lane and must be replaced.
Perform the steps below to replace the waste tank seal. Perform these steps with the
machine in the
operating
position.
Figure 3-21
Summary of Contents for Express 294-115-200
