Express Lane Machine Operation, Maintenance, and Parts Manual
3-30
Rev. Date: 01/07
400-294-002
9. Gently squeeze the outer tabs of the connecter and pull it from the housing on the
control enclosure.
10. Insert the new sensor connector into the housing on the control enclosure and route
the wire to the hole in the base plate.
11. Thread a jam nut onto the sensor and insert the sensor through the hole in the base
plate.
12. From under the base plate, thread the other jam nut onto sensor so the base plate is
sandwiched between the two jam nuts.
13. Tighten the jam nuts until the sensor is securely positioned.
NOTE
To put the sensor in the correct position, the bottom jam nut should be
tightened so it is flush with the base plate and the lens of the sensor flush with
the bottom edge of the jam nut.
3.4.7.3 Replacing The Rear (Approach) Sensor
To replace the rear sensor, complete the steps below. Perform these steps with the
machine in the
operating
position.
Tools Needed:
•
Phillips screwdriver
•
Ratchet and 7/16 socket or 7/16 wrench
•
Wire cutters
Refer to Drawing Number:
•
294-115-053, View B
1.
Remove the screws on each side of
the hood, as shown in Figure 3-32,
and lift the hood off the frame. Set
aside the screws.
Figure 3-32
Summary of Contents for Express 294-115-200
