Express Lane Machine Operation, Maintenance, and Parts Manual
3-24
Rev. Date: 01/07
400-294-002
Tools Needed:
•
Scraper
•
Solvent
Refer to Drawing Number:
294-115-042
1.
Remove the vacuum hose from the waste tank inlet port.
2.
Remove the waste tank from the machine to expose the vacuum motor seal, as
shown in Figure 3-22.
3.
Carefully pull off the waste tank seal.
4.
Scrape off any remaining pieces of the seal and any adhesive.
5.
Wipe the waste tank seal area with a solvent to remove any remaining residue.
6.
Remove the plastic backing from the new waste tank seal.
7.
Center the new seal over the vacuum motor inlet and press firmly.
NOTE
Allow the adhesive 15 to 20 minutes to set before using the machine.
3.4.6 Replacing The Fuses
There are three fuses in the Express, the main power board and two for the solenoids.
They are all located in the control enclosure. The main power board fuse is a 5x20 Slow
Blow, 500ma. The solenoid fuses are 4A subminiatures.
Figure 3-22
Waste Tank Seal
Summary of Contents for Express 294-115-200
