PiXtend eIO Hardware Manual
–
Switch „CONFIG“ - Serial device configuration:
A total of six switches together form the configuration of the serial interface.
Configurations of baud rate, number of stop bits & parity are available for a wide
range of bus requirements.
Select from the table below the desired combination of baud rate, parity and stop bit (s)
and then transfer the corresponding switch order of the table to the switches of DIP block 2
from left to right according to the assignment 1 = switch 1 to 6 = switch 6 ,
A "0" means off position (OFF), the switch is in the down position and a "1" means "on"
position, the switch must be in the up position. The order of the switch goes from left to
right, numbers 1 - 6.
www.pixtend.com
Copyright by Qube Solutions GmbH
35 / 119
Figure 16: DIP Block 2 - CONFIG – serial
configuration
