![background image](http://html1.mh-extra.com/html/quantum/dxi6900/dxi6900_user-manual_3536185276.webp)
Chapter 9: Configuration
Replication Configuration
Quantum DXi6900 User’s Guide
276
l
It is typical for the target DXi to require additional disk space for replication data compared to the
source DXi. This is because complete replication data is sent to the target before old data is deleted.
For optimal performance, if the DXi is a replication target, Quantum recommends keeping the amount
of free space at 20% or more (see
).
To add a replication source:
1. Under
Source DXis
, click
Add
.
The
Add Allowed Source
).
Figure 171:
Add Allowed Source
2. In the
Source Hostname or IP
box, enter the hostname or IP address of the system that will send the
replicated data to the DXi6900.
Note:
To use hostname format, you must specify at least one DNS IP address on the
Network
).
3. Click
Apply
.
Deleting a Replication Source
Delete a system from the list of replication sources if it will no longer send replicated data to the DXi6900.
After the source system is deleted, the DXi6900 will no longer accept replicated data from that system.
To delete a replication source:
1. Under
Source DXis
, select one or more sources to delete.
2. Click
Delete
.
Note:
If a source DXi is deleted from the list, its contribution to the cumulative totals on the
Home
page
are not removed until you clear
Receive
Replication Performance on page 167
).
Changing the Maximum Number of Snapshots
During scheduled or manual data replication, the DXi6900 receives a snapshot from the source system. A
snapshot contains all of the data necessary to fully recover or failback a NAS share or VTL partition to the