SETUP & OPERATION
59
Start-up Sequence
Start up the TABBER in the following sequence:
1.
Turn on the Tabber using the
Main Power Switch
[
1
]
2.
Check that the
Emergency Stop
button/switch [
8
] is in the operate position (released).
3.
Press the
Head Power
button [
2
] on the Control Panel.
Tip:
If the head power button won’t turn on, check the following: exit roller assembly
closed, tab drive cover closed, and the Safety Stop Jumper or control cable is connected.
If the Tabber is being used in-line with other equipment, make sure the Emergency Stop
switches on the other devices are also released, and the power on the other in-line
equipment is also on.
4.
Press the
Transport Power
button
[3]
on the Control Panel
5.
Press the
RUN
key [
11
], located below the soft keys on the Control Panel to start the
Tabber.
6.
Adjust the
Speed Control [5]
to set the speed of the Tabber.
7.
Press the
STOP
key [
10
] located below the soft keys to stop the Tabber. Pressing the
large
Emergency Stop
button [
8
] will shut down the entire Tabber and lock out the other
keys. To restart from an
Emergency Stop
you must repeat this sequence from Step #1.
NOTE:
The maximum speed you can run the TABBER will depend on the number of
tabs you are applying. The speed of the Tabber for applying single tabs is 35,000 pieces
per hour, for applying double tabs it is 30,000 pieces per hour and for applying triple tabs
it is 20,000 pieces per hour. Exceeding these speeds will cause the Tabber to stop.
After the Tabber is setup, the operation of the Tabber is the same whether you are tabbing,
applying labels or stamps. For more information, please refer to the “Setup and Operation”
section of this manual.
Summary of Contents for rena T-950
