SETUP & OPERATION
40
If the
Length
soft key is pressed.
The display will prompt you to enter the piece
length (using the number keypad) or press
“Automatic” for the Tabber to automatically
measure the piece length.
Automatic –
“Automatic Piece Length
Measurement”.
Media can be fed through the
Tabber and measured automatically.
This is
the recommended method.
EXIT
–
Brings you back to the previous
screen.
Press the
Automatic
soft key.
IMPORTANT:
Make sure that the transport
power switch is turned
ON
.
If the Tabber displays “Increase Transport
Speed” or “Decrease Transport Speed”, adjust
the transport speed until the display shows “Feed
1 Product now”.
When the display reads “Feed 1 Product now”;
feed one of your mail pieces through the Tabber.
Note
: Feeding more than one mail piece will cause
an incorrect length to be measured.
The Tabber will measure and display the piece
length.
Verify the measurement.
It must be accurate (+ or - 0.250”).
Tip:
If the Tabber measures the piece to be longer than the actual piece length; then more than one piece may
have been fed, or the media may be slipping or hesitating as it feeds. Check/Adjust the transport system.
If the Tabber measures the piece to be shorter than the actual piece length; then the media may not be feeding
straight (missing the sensor), or a hole in the media may be traveling through the sensor, or the sensor may be
getting reflection off the mail piece. If using a high gloss media; the sensor intensity may need to be adjusted
lower, by a qualified Service Technician.
If the media passes through without the Tabber providing a measurement; then the wrong media sensor may
have been selected, or the media sensor may be dirty. Check to be sure the correct media sensor was selected.
Try cleaning the sensor as described in this manual.
These problems need to be corrected before the Tabber will function correctly.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Length Backing EXIT
Enter piece length and press SAVE key
Current Value: 6.153”
Automatic
EXIT
Enter piece length and press SAVE key
Current Value: 6.153”
Automatic
EXIT
Enter piece length and press SAVE key
0.00” Current Value: 8.523”
Status: Pieces: 1
Automatic
EXIT
Feed 1 Product now
Status:
EXIT
Summary of Contents for rena T-950
