7
Insert the new SIMM into the SIMM connector.
a
Hold the SIMM at a 45° angle to the controller board, with the notch on the
right side and the bottom edge in the connector.
»
Note:
The first SIMM must be added to the DRAM0 SIMM connector. Both
DRAM0 and DRAM1 must be occupied before adding a third SIMM to
DRAM2.
...................................................
...................................................
Summary of Contents for Magicolor 2 plus
