QMS Magicolor 2 plus, Manual

Page: 44 / 90

'(
4 When downloading is complete, reboot the printer.
The emulation should be listed in the Options section of the printer’s startup page,
in the Administration/Emulation printer’s configuration menu, and on the advanced
status page.
')("
» Note:
Before you begin this procedure, your printer and PC (or UNIX workstation)
must be connected to an Ethernet network running TCP/IP and have valid IP
addresses.
1 If your PC is running Windows, change to DOS.
2 Insert the emulation disk in your PC’s 3.5" disk drive, and change to that
drive (for example, if you’re using the A drive, type
a:
↵
).
3 If you want to download the emulation from a UNIX workstation, copy the
installation file from the emulation disk to a temporary directory on your
UNIX workstation.
4 Turn on the printer, and wait for
IDLE
to appear in the message window.
5 Open an ftp session at your PC or workstation by typing one of the following
commands:
ftp printername
↵
(for example, ftp pctdev6
↵
)
ftp ipaddress
↵
(for example, ftp 161.33.130.45
↵
)
6 When prompted for a user name and password, press Enter for both.
An ftp
>
prompt displays.
7 At the
ftp>
prompt, change to binary mode by typing
bin
↵
8 At the
ftp>
prompt, send the emulation file to the printer’s hard disk by
typing
put filename .ps
↵
where
filename
is the name of the installation file.
The printer’s message window reads
1 Active Job
to indicate that the emula-
tion is being downloaded to the hard disk. The
ftp>
prompt returns when the
emulation has finished loading.