QMS Magicolor 2 plus, Manual

Page: 60 / 90

*
&
Properly installed devices also appear in the “Options” section of the startup page (if
it’s enabled) and on the status page as
%%disk
x
%.
(
x
is a 7 for an internal IDE hard
disk and 0-4 or 6 for any external SCSI hard disks or drives, depending on the SCSI ID
set on the back of the device.)
./0 $
Keep the following in mind when using Jaz and Zip drives:
Data can be backed up only to Jaz and Zip drives, not to external SCSI hard disks.
Jaz and Zip drive information shows up on the startup and status page only if
media is present in the drive.
If a Jaz or Zip drive is attached to the printer but no media is present, you will
experience a long delay (30 seconds or more) when you take the printer off line
and put it back on line.
Jaz and Zip drives cannot be used for disk swapping or accounting. They can be
used only for font and file storage and for data backup and restoration.
"
Access the Administration/Disk Operations menu, and then press the control panel
keys in the order shown in the following table. The printer responds by displaying a
status message in the message window (DSK refers to the device, and
#
is the device
number).
» Note: You may need to press the Next key one or more times to advance through the
list of selections or options.
Press this
key... to... and the message window
reads...
Select Access the Disk Operations/Format Disk menu
FORMAT DISK
Select Access the Format Disk/Dsk#: menu.
DSK
#:
Next or
Previous Advance through the list of attached devices.
DSK #:
Select Select the device and display a format
confirmation message.
ARE YOU SURE?