QMS Magicolor 2 plus, Manual

Page: 71 / 90

2 *
0
7 Remove the lower input feeder
cover plate.
You will switch this cover plate with the
one from the printer after the cables
have been connected.
8 Locate the cable at the left rear of
the input feeder, and connect it to
the printer.
9 Reinsert the two cover plates.
Put the one originally on the printer on the input feeder, and put the one originally
on the input feeder on the printer.
10 Snap the plastic side covers onto
the appropriate sides of the input
feeder.
The input feeder is now installed.
11 For best output quality and longest
consumables life, install the printer
on a hard, flat, level (within 1.5°) sur-
face capable of supporting about
126 lbs (57.1 kg).
A surface can be tested for levelness
with a standard round pencil. If the
pencil rolls, the surface is not level.
» Note:
If you move the printer with the lower input feeder attached, lift the unit by
the four bottom corners of the feeder, not by the feeder's cassette slot and not by
the printer itself.
12 Plug the printer in and turn it on.
» Note:
In compliance with UL guidelines, “The appliance inlet is considered to be
the main disconnect device.”