3
Remove the printer’s controller board.
Loosen two screws, one on each end of the I/O connector panel, and, using the
tab on the lower side of the connector panel, pull the controller board from the
printer.
»
Note:
The illustration shows the printer without the duplexer. However, the
instructions are the same for all models.
4
Position the controller board on a flat surface so the controller board lies flat
and the I/O connector panel is facing you.
5
If you need to remove a SIMM before installing one, remove it as follows;
otherwise skip to step 6.
»
Note:
If all the SIMM connectors are filled and you want to install more memory,
you have to exchange one or more SIMMs for SIMMs with a greater memory
capacity.
a
Using both thumbs, pull the latches (one on each side of the SIMM connector)
outward.
b
Tilt the SIMM backwards to a 45° angle away from the SIMM connector.
Summary of Contents for Magicolor 2 plus
