
2 *
3
Set the printer on top of the input
feeder.
Be sure to align the printer and input
feeder as precisely as possible. This
makes the following steps easier.
4
Install the two metal brackets under-
neath the sides of the printer.
Holding the bracket at a slight angle,
slide it up into the hole underneath the
printer before setting it to vertical.
5
Make sure that the hole in each
metal bracket is lined up with the
corresponding hole on the input
feeder.
6
Use the thumbscrews to attach the
two brackets to the lower input
feeder.
Summary of Contents for Magicolor 2 plus
