PSC Scanning SP*ACE, User Manual

Page: 21 / 190

R44-1132
17
W
ALL
M
OUNT
I
NSTALLATION
I
NSTRUCTIONS
Make a copy of the mounting template on the next
page and tape it where you will mount the scanner.
Drill two 3/32" (2.4mm) pilot holes for the mounting
screws.
Install the two pan-head screws from the mounting
hardware kit leaving 1/8" (3.2mm) space between
the wall and the screw head.
Attach the power and interface cables to the scanner.
Be sure to tighten the screw that secures the inter-
face cable to the scanner. Route the cabled as
shown.
Do NOT connect cables to power or terminal at this
time.
Remove and discard the keyhole covers.
Install the scanner over the two screw heads (A).
Slide the scanner down approximately 1/2"
(12.7mm) (B) to lock it in place.
Proceed to the instructions titled Connecting the
Scanner and Power-Up Procedure to complete the
installation.
1
2
3
4
5
6