PSC Scanning SP*ACE, User Manual

Page: 19 / 190

R44-1132
15
P
EDESTAL
I
NSTALLATION
I
NSTRUCTIONS
Refer to the figures on the facing page when following these steps.
Locate the mounting position of the scanner and
install the mounting plate.
Route the cables through pedestal and connect them
to the scanner. Tighten the screw that secures the
interface cable to the scanner. Do NOT connect
cables to power or the terminal at this time.
Remove the appropriate cable routing knockout.
The three cable routing directions shown in step five
on the opposite page will help you determine which
knockout to remove. Remove all rough edges
around the knockout hole.
Attach the pedestal to the scanner using a flat-blade
screwdriver to tighten the captive screws.
Route the cables through the base. Three routing
options are shown.
Lower the scanner onto mounting plate and press
down to secure the scanner to the plate. Proceed to
the instructions titled
Connecting the Scanner and
Power-Up Procedure to complete the installation.
1
2
3
5
6
4