Protocol Propaq 242, Directions For Use Manual

Page: 45 / 120

Propaq CS Directions for Use 45
Monitoring
CO
2
Warning
Before using an airway adapter, always look through the window lumen and inspect the adapter for
inadvertently lodged obstructions and for window integrity.
If the sensor does not easily slide onto the adapter, do not attempt to force these components together. They
fit together in only one way. Take care not to damage the glass window.
After attaching the sensor to the adapter, check for proper placement. Check the sensor and adapter
periodically during monitoring to make sure they are properly connected and the adapter is not clogged by
obstructions or debris.
When attaching the airway adapter, position the adapter so the sensor is on top to avoid fluid collection in the
sensor airway slot. Any concentration of fluids here can cause inaccurate CO
2
readings.
When connecting the adapter and sensor to the ventilator circuit, do not use the adapter and sensor as a
wrench to twist the adapter into the ventilator circuit. Such action could damage the adapter and sensor.
Always check to make sure there are no leaks in the breathing circuit. Check all of the connections.
3.
Plug in the CO
2
sensor cable to the Mainstream CO
2
connector on the monitor left side panel.
Warning
When disconnecting the CO
2
sensor from the tracheal or endotracheal tube, check the sensor to determine
how hot it is. If it is too hot for patient comfort, do not allow it to come into contact with the patient.
4.
See page 48 and set up the CO
2
display and alarm limits.
Note
When disconnecting the airway adapter from the ventilator circuit, always detach the CO
2
sensor from the airway
adapter before removing the airway adapter from the ventilator circuit.