Protocol Propaq 242, Directions For Use Manual

Page: 97 / 120

Propaq CS Directions for Use 97
Ref
erence
Factory Default Settings
The monitor is shipped from the factory with these preset default settings. For information about how
to customize your monitor settings, see page 23.
Factory Default Settings
Setting Factory Default
Date
1
MO/DA/YR. This setting is automatically updated whenever it is
changed during use (continuously programmed).
Decimal
1
. (Period) This setting is automatically updated whenever it is
changed during use (continuously programmed).
HR/PR Sweep 25 mm/s
RR/BR Sweep 6.25 mm/s
Alarm Tone MEDIUM
HR/PR TONE LOW
HR/PR SOURCE ECG
RR/BR Source CO
2
if available or ECG (not programmable)
Patient Mode Adult
Display Brightness Normal
ECG Bandwidth Monitor
ECG Size 1 mV/cm
ECG1 Lead II
ECG2 Lead V
ECG Filter
1
60 Hz. This setting is automatically updated whenever it is changed
during use.
ECG Pacer ON
RESP size 2X
RESP lead Ld2
RESP sweep 6.25 mm/s
RESP monitoring ON
RESP window ON
IBP Range 0 to 180 mmHg
IBP Rescale 0 to 140 mmHg (not programmable)
IBP Mode RESCALE
Invasive Pressure Formats Label dependent
NIBP Mode MANUAL
NIBP Auto Time 15 min
NIBP Smartcuf ON
SpO
2
SIZE 2x
SpO
2
C-LOCK OFF
SpO
2
Response NORMAL
TEMP F/C
1
Celsius
CO
2
Range 0 to 60 mmHg
CO
2
Sweep 6.25 mm/s
CO
2
Response NORMAL
CO
2
Units
1
mmHg
CO
2
Gas Compensation OFF
Sidestream CO
2
Flow Rate Adult: 90 ml/minute
Ped: 90 ml/minute
Neonate: 90 ml/minute
(The flow rate cannot be programmed to a different value in a
Custom Patient Mode, see page 23.)
Display Wave Select Adult and Pediatric Patient Mode: ECG1, ECG2, P1, P2, and CO
2
=
ON, and large NIBP numerics are displayed (in order of priority);
SpO
2
and RESP = OFF.
Neonatal Mode: all waveforms are ON and large NIBP numerics are
displayed (in order of priority).