PRONAR PRONAR N262, Operator'S Manual

Page: 88 / 145

Pronar N262 N262/1 SECTION 4
4.16
•
The chain conveyor speed is reduced by turning the knob clockwise to "1"
setting.
•
The chain conveyor speed is increased by turning the knob
counterclockwise, maximally to "8" setting.
ATTENTION
Proper operating range of the regulator starts from the second rotation of the knob. Oil
flow, hydraulic motor rotation and chain conveyor speed are increased by turning the
knob anticlockwise. The scale of the knob is from 1 to 8 (figure (4.3)). The maximum speed
of the conveyor is achieved when the knob is turned until resistance is felt.
4.5.2 ADJUSTMENT OF SPREADING WIDTH
Before manure spreading, carry out spreading test because manure may have various
characteristics. Spreading width differs depending on type of material spread (e.g. it is
smaller for dry manure and greater for wet manure). In order to enable matching of spreading
width to type of material spread, there are 6 adjustment openings for each blade on a disc.
Spreading width is adjusted by changing the position of blades (5) on spreading discs (1) and
(2). Spreading width is decreased by shifting the blades in the direction of spreading disc
rotation.
Changing the position of blades on the spreading disc is conducted as follows:
Loosen bolt (6).
Unscrew nut (7) underneath the disc and take out bolt (8),
Shift the blade in such position as to install bolt (2) in a proper hole on the
disc.
Lock spreading blade in a selected position by means of nut (7) and tighten
bolt (6).
Repeat the procedure for each blade to ensure that all blades are set in the
same way.