PRONAR PRONAR N262, Operator'S Manual

Page: 81 / 145

SECTION 4 Pronar N262 N262/1
4.9
floor conveyor tension and adjust if necessary – see chapter 5.12 „CHECKING
AND ADJUSTING THE TENSION OF FLOOR CONVEYOR CHAIN”.
DANGER
Do NOT use a malfunctioning or incomplete spreader.
Careless and improper use and operation of the manure spreader, and non-compliance
with the recommendations given in this operator's manual is dangerous to your health.
Prior to connecting individual system conduits, the user must carefully read the tractor
Operator's Manual and observe all Manufacturer's recommendations.
4.3 HITCHING TO TRACTOR
Prior to attempting to hitch the manure spreader to tractor, make sure that the tractor is
immobilised with parking brake. The manure spreader may be attached only to the tractor
equipped with all necessary connections (electric, pneumatic and hydraulic connections) and
the tractor hitch in accordance with the requirements of the manure spreader Manufacturer.
DANGER
When hitching, there must be nobody between the manure spreader and the tractor.
When hitching the machine, tractor driver must exercise caution and make sure that
nobody is present in the hazard zone.
Make sure that there is nothing and nobody inside the load box.
Be especially careful when hitching the machine to the tractor.
When connecting the hydraulic conduits to the tractor, make sure that the tractor and
manure spreader hydraulic system are not under pressure.
In order to hitch the spreader to tractor, proceed as follows
Immobilise the manure spreader with parking brake.
Position agricultural tractor directly in front of drawbar eye.
Reverse tractor and connect the conduit marked with decal (28)– table (2.1)
(straight hydraulic support). If the spreader is equipped with the hydraulic
system controlled from the manure spreader, connect two hydraulic conduits
marked with decals (23) – table (2.1) in the form of arrows indicating the
correct direction of hydraulic oil flow to the manifold - figure (3.8), next, set the