pro bel TX 410, Operator'S Manual

Page: 79 / 89

Pro-Bel TX 410 operators guide
HU-TX 410OG
79
The current source for each bus, when selected, is shown at the
top of the page.
3
To set the audio for a source other than the one shown, press the
appropriate source selection button in the selected row.
Caution: It is not recommended that sources are changed on
the PGM bus as this will affect the main system output.
4
To select the type of control for adjusting audio gain,
press the
<MARRY>
button until the type wanted is
highlighted.
The button toggles between <MARRY> and <SPLIT> . When set to
<MARRY> use either shaft encoder to adjust the gain. When set to
<SPLIT> , the left and right shaft encoders set the gain for the left
and right channels respectively.
5
To adjust the gain for the selected source, turn the third shaft
encoder(s) to increase/ decrease gain, or press the
<UNITY GAIN>
button to set the source to unity gain.
Caution: If the source you are adjusting is also selected on
the PGM bus, the level will be altered on-air.
6
To change the stereo/mono selection for the source, press the
<ST> (stereo), button until the type wanted is highlighted. The
button toggles between <ST>, <MONO> (mono), <A> and <B> .
<ST> routes the left and right channels as a stereo pair to the bus
output, <MONO> derives a mono output of the left and right
channels and routes it to the bus output, <A> routes audio
channel A (left) to both outputs, <B> routes audio channel B (right)
to both outputs.
7
If either <ST> (stereo) or <MONO> (mono) have been selected,
<PHASE REV B > can also be added to reverse the phase of audio
channel B.
Once all channels have been set, press <
HOME
> to display the home
screen.