pro bel TX 410, Operator'S Manual

Page: 78 / 89

TX 410 operators guide Pro-Bel
78
Issue 2
15.1 Buttons and controls
Buttons on the audio setup screen associated with source audio
parameters provide ‘toggle’ operation to select the required settings and
include:
<AUX/PGM/PST> - used to select the bus to be adjusted.
<MARRY/SPLIT> - used to select either married or individual control
of the gain for each channel.
<0> - Sets the audio gain for the currently selected source to unity. This
button is only active if the source selected is not at unity gain.
<ST/MONO/A/B/PHASE REV B> - used to select either stereo, mono,
channel A to both, channel B to both, or phase reversal on channel B.
<A> and <B> are only available for single level audio systems as multi
level systems use audio routing. (see chapter 16).
Note: If a phase reversal has been performed on a source, the red
indicator will light at the end of bus that the source is selected on.
Shaft encoders – These are used to adjust the gain for the selected
source. The effect of turning these controls can be seen on the screen.
15.2 Setting up the source audio gain
When using the audio (gain) setup screen, select a bus by pressing one
of the bus select buttons to the left of the screen. To select a source on
that bus, press the source button in that bus row on the lower console.
1
From the home screen, press the <AUDIO SETUP> button.
The audio setup screen is displayed, with AUX selected by default.
The name of the current AUX source is shown at the top of the
page.
2
To set audio gain for a source on a different bus, press the <AUX>
button to toggle between AUX, PST and PGM. until the correct bus is
indicated.