Clean DCFT Release Sheets and Club &
Conveyor Belts
Daily
PR34 D01
527-504revM_EN
54
Printed in USA 12/20 © 2020
Prince Castle DCFT
-MCD V
ertical T
oaster
Daily
PR34
D01
2
(continued)
Spray a clean, sanitizer-
soaked towel with Solidsense
APSC or McDonald’s DR
Concentrated Disinfectant
Cleaner solution and use to
wipe release sheet clean.
Clean the entire surface of the
release sheet.
Immediately rinse the sheet
with a clean, sanitizer-soaked
towel.
Flip the release sheet over
and repeat cleaning
instructions.
Rinse this side of sheet.
Chemicals
Sanitizer solution, Solidsense
APSC or McDonald’s DR
Concentrated Disinfectant
Cleaner
Install release sheet, making
sure that sheet is centered
over platen and the crease in
sheet is centered.
Insert the release sheet over
the center bar of the in-feed
cover with one end of the
sheet in the Crown slot and
one end in the Heel slot.
Position the crease on the
release sheet on top of the
in-feed chute center bar,
making sure that the sheet
corners are not curled
exposing the platen.
Check to see that 12.7 mm
(1/2") of release sheet
extends below each side of
the platen.
Install the Release sheet clip.
NOTE:
If 12.7 mm (1/2") of the
release sheet does not extend
below the bottom of the platen,
then the sheet is not properly
positioned.
NOTE:
Make sure release sheet
is completely dry before installing.
NOTE:
When installing release
sheet, you may flip inside-out and
use the other side if needed.
3
Clean conveyor and club belts.
With power off, remove gloves
from hands to unscrew and lift
lid and open front conveyor
door.
Put heat-resistant gloves back
on to clean.
Using the sanitizer-soaked
towel, clean the front main
conveyor and club belts.
Close front door, power unit
ON, count 13 seconds to
reveal unclean side of belt,
power unit OFF, open door
and repeat cleaning using the
sanitizer-soaked towel.
Close door, power unit ON,
count 13 seconds again,
power unit OFF, open door
and repeat cleaning.
Wipe down the inner panel of
the conveyor access door with
a clean, sanitizer-soaked
towel sprayed with Solidsense
APSC or McDonald’s DR
Concentrated Disinfectant
Cleaner.
Repeat the belt cleaning
process for rear main
conveyor belt, rear club belt
and rear inner panel.
Chemicals
Sanitizer solution, Detergent
solution or McDonald’s DR
Concentrated Disinfectant
Cleaner
Close the conveyor access
door and secure.
Install the Infeed Cover
Re-tighten top cover screws.