527-504rev
M
_EN
27
Printed in USA 12/20 © 2020
Vertical Toaster
DCFT-MCD Series
Slide in club assembly partially.
22
Use flat head screwdriver to open clip and put excess
high limit switch wire underneath
23
Install high limit switch into club platen. (Apply AOS
Silicone paste if necessary)
24
Close clip over excess wire.
25
Connect temp probe wires (Red/White female to White
male) and (Purple Female to Red/White Male)
26
Use high temp zip tie to secure high limit switch and
club harness (Zip-tie that was removed).
27
Remove/Replace Club Assy (cont.)
Tuck excess wire slack so it does not get pinched
when installing club.
28
Put belt on club transfer gear.
29
Align club shafts with bearing holes.
30
Wrap belt over shaft drive gear.
31
Push down club assembly into unit evenly.
32
Use 11/32" nut driver to attach (4) main club assembly
nuts.
33
Hook cover sheet over terminal block.
34
Use 11/32" nut driver to install back terminal cover top
nut.
35
Use flathead screw driver to install bottom back cover
screw.
36
