Printed in USA 12/20 © 2020
18
527-504rev
M
_EN
Vertical Toaster
DCFT-MCD Series
Unplug the Unit.
1
Remove/Replace Crown Compression Adjust Assy
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
WARNING
Open and remove back door.
2
Remove screw and
nut that secure rear
gear cover to
intermediate support.
Set cover, nut, and
screw aside.
3
Nut
Cover
Screw
Loosen thumbscrew on left side panel. Set panel
aside.
4
Partially remove club assembly. Refer to Page 26, step
15-17.
5
6
Remove retaining ring from shaft. Set ring aside.
Retaining
Ring
Remove compression knobs from right side panel.
7
Remove screws (7) that secure right side panel to
frame. Set screws aside.
8
Disconnect electrical connectors (2) from panel. Set
panel aside.
9
10
Remove nuts (4) that secure drive train cover and drive
train to frame. Disconnect electrical connectors from
drive train. Set nuts, cover, and drive train aside.
Drive Train
Cover Nuts
11
Cut cable ties along bottom half of bundled wires
coming from crown heater.
Cable Ties