23
Revision 00 EN - 01/2021
HP-MSM-HB
35,0(6
The magnetically held alignment tool can fall down during shipping. Dirt may enter the objective. Therefore,
the objective of the HP-MSM-HB is closed with a black transport lock.
Before removing the transport lock, the area around the aperture must be cleaned with clean compressed air
and the purge air must be connected to the HP-MSM-HB.
If the purge air is not connected, dust can enter the objective directly when the cyclone is mounted.
X
Turn on the purge air (see chapter 8.2 on page 30)
X
Remove the transportation lock by loosening the four screws.
Transportation Lock
Sealing Ring
Fig. 7.3:
Transportation lock at the beam entrance
X
Store the transportation lock and the O-ring in a clean, sealable plastic bag. If you store or transport the
device, you should remount the transport lock.
X
Fasten the cyclone to the objevtive with the four screws.
7.3.3
Positioning the pilot laser beam above the cyclone
Laser Beam
Alignment tool
Fig. 7.4:
Alignment tool for HP-MSM-HB
